The last few days I've done.
I once put some money in hand and bought silicone cables and ball bearings and LEDs.
The Silicon cable is wonderfully flexible and I've refined the wiring harness.
The leads of the ESCs to the motors on the boom are now finished.
A major issue is the back Boom.
Here is indeed a power to the rear of the engine swings and I also had some problems in the past. In
Splint3r I first worked with a servo in the center, which was very cumbersome and not very easy to maintain.
why I have moved the servo arm to the back and steer the rear end of a servo horn. The only problem is the storage of the movable part. So far I have used this 8mm carbon tube in which a 6 mm carbon tube rotates. The also do quite well, but not without friction. So I wanted to work with camps.
 |
| axle bearings with snap ring and 5mm/8mm |
Leider bin ich dabei in eienr Sackgasse stecken geblieben, ich konnte die Achse nicht spielfrei im ausleger fixieren, und bin wieder zurück auf mein altes Konzept mit dem Carbonrohr, da dies für die Fixierung im Ausleger einfach das Beste war.
Dabei raus gekommen ist Folgendes:
Im Vergleich zu Splint3r ist der Anschluss für das Servohorn nun direkt am Trägerplastik und ich brauche keinen Aluhebel mehr. Außerdem sit das ganze leichter to change than before and faster.
0 comments:
Post a Comment